Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   - 3.4. An engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. The storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. The coil () ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. The block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. A pressure and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay
      3.4.15. The basic malfunctions of an electric equipment
      3.4.16. That it is necessary to know to the owner of the car with инжекторным the engine
      3.4.17. A turbo the doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


3.4.8. The block of electronic ignition
1. Disconnect from the electronic block located under the main cylinder of brakes (engine V6), a socket and execute following checks, being guided by the scheme (subsection 12.2.2 see.)
2. Check up presence of pressure of the battery on a conclusion 9 sockets.
3. Check up presence of pressure 5 In on a conclusion 4 sockets. If pressure is not present, hand over the processor block in repair.
4. Check up presence of fluctuating pressure 0,1–4,5 In on conclusions 5, 6 and 7 sockets (for this purpose ask the assistant to include a starter). If pressure is not present, hand over the processor block in repair.
5. Check up reliability of connection with weight of a conclusion 3.
6. If checks have yielded positive result disconnect sockets on each coil and check up presence of a signal by means of a light-emitting diode (subsection 3.4.5 see.). If the signal is, check up integrity of a chain from the block of ignition to the coil. If the chain is serviceable, the ignition block replace.