Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   - 3.4. An engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. The storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. The coil () ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. The block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. A pressure and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay
      3.4.15. The basic malfunctions of an electric equipment
      3.4.16. That it is necessary to know to the owner of the car with инжекторным the engine
      3.4.17. A turbo the doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.4.13. The starter electric motor

THE GENERAL DATA

Starter conclusions

1. The traction relay
2. A starter
3. A vice
4. The switch

If there are suspicions on malfunction of a chain of a starter be convinced that the battery is charged, check up cleanliness reliability of fastening of wires, serviceability of the blocking switch of position Park/Neutral or couplings (on and / m from a manual transmission). Check up also serviceability of the relay of a starter (is in the assembly block of the relay in a motor compartment).

If the starter electric motor does not rotate at all at key turn check up pressure on the traction relay. If pressure is, remove a starter and check up.

At slow rotation of a starter check up pressure and a current at start-up which at not so low temperature, after no more 10 with the ambassador of inclusion of a starter should be accordingly not more low 8,0 In and 250–400 A.Esli a starting current do not correspond to the specified limit a starter replace, preliminary having checked up serviceability of wires, connections and the battery.

If pressure on a starter is, but the starter does not rotate, remove a starter for check. For starter check collect the scheme, having connected wires the specified conclusions (fig. starter Conclusions see). If обгонная муфта it is put forward, but the starter does not rotate, the starter is faulty. If clicks are listened, and муфта is not put forward, are faulty either the relay, or a starter.

Removal

Details of installation of a starter (the 4-cylinder engine)

1. A socket
2. A starter
3. A power cable

Details of installation of a starter (the 6-cylinder engine)

1. A socket
2. A starter
3. A power cable

PERFORMANCE ORDER

1. Remove the battery.

2. Remove актюатор the cruise-control.

3. Disconnect from a wire starter.

4. Turn away starter bolts.

5. Remove an arm from the top part of a starter. For this purpose release 1–2 bolts of an arm, приопустите a starter and turn away other bolts.

Installation

Installation is carried out upside-down.