Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crosspieces
      12.1.5. Breakers
      12.1.6. The relay
      12.1.7. The breaker of indexes of turn / of the alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. The lock of ignition and a lock drum
      12.1.10. Switches of the panel of devices
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. A guard of devices
      12.1.13. The screen wiper electric motor
      12.1.14. The receiver and dynamics
      12.1.15. The aerial
      12.1.16. A heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. The case галогенной headlights
      12.1.20. A sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. Cruise-control system
      12.1.24. The electric drive window lifterа
      12.1.25. The electric drive of door-locks
      12.1.26. Safety pillows
   + 12.2. Electroschemes


12.1.9. The lock of ignition and a lock drum

The diagramme for check of the lock of ignition

Key position
Tested conclusions
Chain presence
There is no chain
2 – 3
There is a chain
2 – 3 – 4
6 – 7
There is a chain
1 – 2 – 4
6 – 7 – 8
There is a chain


1. Disconnect a socket of the lock of ignition, having found it on wires from the lock.
2. An ohmmeter or a control lamp check up chain presence between the specified conclusions, in different positions of a key. Replace the lock if results at least with one of checks the negative.


1. Disconnect the battery from weight.
2. Translate a key in position АСС.
3. Remove a wheel.
4. Remove both casings of a steering column.
5. Remove from a shaft of a wheel a combination of switches.

Replacement of the lock of ignition

1. Disconnect from the lock of ignition of a wire.
2. Turn away fastening screws (are specified by arrows) and remove the lock.
3. Installation is carried out upside-down.

Replacement of the switch (drum) of the lock

1. Press a thin screw-driver подпружиненный a pin.
2. Translate a key in position АСС, press a pin and remove the lock switch.
3. At lock installation press on a pin and insert the switch into a nest on a steering column before fixing by a pin which should come into an aperture on a steering column.
4. Further assemblage is carried out upside-down.