Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crosspieces
      12.1.5. Breakers
      12.1.6. The relay
      12.1.7. The breaker of indexes of turn / of the alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. The lock of ignition and a lock drum
      12.1.10. Switches of the panel of devices
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. A guard of devices
      12.1.13. The screen wiper electric motor
      12.1.14. The receiver and dynamics
      12.1.15. The aerial
      12.1.16. A heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. The case галогенной headlights
      12.1.20. A sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. Cruise-control system
      12.1.24. The electric drive window lifterа
      12.1.25. The electric drive of door-locks
      12.1.26. Safety pillows
   + 12.2. Electroschemes


75acfaa4 Soap 2 day

12.1.16. A heater of back glass
THE GENERAL DATA

The heater consists from thin проволок, спеченных with a glass surface.

Small destructions проволок can be repaired independently.

Check

PERFORMANCE ORDER
1. Include ignition and a heater. If on a heater there is a pressure, but heating is not present, arrive as follows.
2. Dress on probe the voltmeter the combined strip of an aluminium foil and press down a finger to a heater thread.
3. If pressure is equal in the thread centre 6 In the thread is serviceable if pressure is equal 12 In the thread it is torn off (breakage takes place between the centre of a thread and weight). If pressure 0 In the thread is torn off between the centre and feeding conclusion of a heater.
4. If threads are serviceable, connect (-) – a conclusion of a heater to weight. If voltmeter indications change, connection with weight the unsatisfactory.
5. The place of breakage of a thread can be established conducting aluminium contact on probeе the voltmeter on a thread aside from (+) – a conclusion to (-) – to a heater conclusion. In a place of breakage the voltmeter indication should fall from several volt to 0.

Repair

PERFORMANCE ORDER
1. Срастить the torn off thread of a heater it is possible by means of special эпоксидного spending structure (is available on sale).
2. Disconnect a heater and wait full cooling.
3. A steel sponge cautiously располируйте the damaged site also wipe spirit.
4. Impose on the damaged site a mask from a sticky tape.
5. Prepare pitch, being guided by the instruction.
6. Put structure on a crack in a mask, smearing approximately on 18 mm in both parties.
7. Later 24 hours unmask.