Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crosspieces
      12.1.5. Breakers
      12.1.6. The relay
      12.1.7. The breaker of indexes of turn / of the alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. The lock of ignition and a lock drum
      12.1.10. Switches of the panel of devices
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. A guard of devices
      12.1.13. The screen wiper electric motor
      12.1.14. The receiver and dynamics
      12.1.15. The aerial
      12.1.16. A heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. The case галогенной headlights
      12.1.20. A sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. Cruise-control system
      12.1.24. The electric drive window lifterа
      12.1.25. The electric drive of door-locks
      12.1.26. Safety pillows
   + 12.2. Electroschemes


75acfaa4

12.1.3. Safety locks
THE GENERAL DATA

Arrangement of the block of safety locks (Avalon)

The block of safety locks on cars Avalon is mounted under the panel of devices to the left of a steering column.

The block of the relay and safety locks (Solara and Camry)

On cars Solara and Camry the uniform block of the relay and safety locks is located in a motor compartment. On cars Avalon blocks of the relay and safety locks the separate.

Relay arrangement

Some relays are mounted near to a suspension bracket cap from outside the driver.

Chains of an electric equipment of the car are protected by safety locks, breakers or fusible crosspieces. The assembly block of safety locks is mounted in salon or in a motor compartment, depending on year of release and car model.

Safety locks are established on contacts ножевого type and get by hand.

The fused safety lock is easily found out on appearance.

It is possible to check up also pressure on conclusions. The safety lock has fused if the voltmeter shows pressure. To replace a safety lock get faulty and insert new, having pushed it into a nest.

The rated current of a new safety lock should correspond in accuracy to a current of the replaced. The rated current is specified on a safety lock. It is forbidden to use wire pieces instead of a safety lock. If the new safety lock immediately fuses, find the reason and eliminate. As a rule blowing it is caused by short circuit of wires because of retyranny of isolation.