Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crosspieces
      12.1.5. Breakers
      12.1.6. The relay
      12.1.7. The breaker of indexes of turn / of the alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. The lock of ignition and a lock drum
      12.1.10. Switches of the panel of devices
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. A guard of devices
      12.1.13. The screen wiper electric motor
      12.1.14. The receiver and dynamics
      12.1.15. The aerial
      12.1.16. A heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. The case галогенной headlights
      12.1.20. A sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. Cruise-control system
      12.1.24. The electric drive window lifterа
      12.1.25. The electric drive of door-locks
      12.1.26. Safety pillows
   + 12.2. Electroschemes


12.1.6. The relay

Arrangement of the block of safety locks (Avalon)
The block of safety locks on cars Avalon is mounted under the panel of devices to the left of a steering column.

The block of the relay and safety locks (Solara and Camry)

On cars Solara and Camry the uniform block of the relay and safety locks is located in a motor compartment. On cars Avalon blocks of the relay and safety locks the separate.

Relay arrangement

Some relays are mounted near to a suspension bracket cap from outside the driver.

On considered cars of the relay are included in chains of such consumers as units of fuel system, a starter, antifog headlights, a sound signal. Relays are applied to operated inclusion and switching-off сильноточного the consumer under the influence of an electric signal of low power. Relays are mounted in assembly blocks in a motor compartment. The relay can be got and checked up, the faulty relay is replaced. Relay marks are put on its case or on panels of the assembly block.


Designations of conclusions of the typical 4-contact relay

Not typical 4-contact relay

On some 4-contact relays there are conclusions with numbers 1,2,3 and 5, however, their appointment precisely same, as in the relay with conclusions 1 – 4.

Designations of conclusions of the typical 5-contact relay

1. The most reliable results are given by check with use of the scheme of inclusion of the relay. If the inclusion scheme is absent, execute checks taking into account the following. The pair of conclusions of any relay is connected to the coil providing operation of the relay. Other conclusions become in pairs isolated or disconnected at запитывании coils. As a rule, distributing of conclusions of the relay is specified on its case.
2. Connect one of conclusions of the coil of the relay to a positive conclusion of the battery through a wire with a thin delay as a safety lock. The second conclusion connect to weight. After connection click should be listened. If click is not present, change polarity of connection (which should be observed on some relays).
3. Check up chain presence between relay conclusions according to marks on the case.
4. If results of checks negative the relay replace.