Toyota Camry

1996-2001 of release

Repair and car operation


Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Technical characteristics
   6.3. Pressure dump in fuel system
   6.4. The fuel pump and pressure of fuel
   6.5. Fuel tubes and connections of tubes
   6.6. Removal and installation of the fuel pump
   6.7. A regulator of pressure of fuel
   6.8. The gauge of the index of level of fuel
   6.9. A fuel tank
   6.10. Cleaning and repair of a fuel tank
   6.11. A casing of the air filter
   6.12. An accelerator rope
   6.13. Electronic system of injection of fuel
   6.14. A throttle
   6.15. A fuel highway and injectors
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

6.13. Electronic system of injection of fuel
THE GENERAL DATA

The pulse multidot system of injection of fuel includes three subsystems: system of a fence of air (the air filter, воздухозаборные branch pipes, the gauge of a stream of air, a throttle, the monitoring system of idling and an inlet collector), system of the electronic control and system of giving of fuel (the fuel pump, a regulator of pressure of fuel, fuel injectors and a fuel highway, the relay of fuel system).

Check of system of electronic injection of fuel includes check of functioning of all its subsystems and elements of subsystems.

Check

PERFORMANCE ORDER
1. To check up injectors, get the engine and put to each of them a special stethoscope. If you hear clicks, means, the injector functions normally.
2. If the injector does not click, connect to contacts of a wire of each injector a special lamp. If the lamp blinks, means, on injector contacts correct pressure moves.
3. Muffle the engine, disconnect wires from injectors and measure resistance of each injector by means of an ohmmeter. Compare the received results to technical requirements.