Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
- 11. A body
   11.2. Vinyl furnish
   11.3. An upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. A windscreen and motionless glasses
   11.8. The central lock
   11.9. A cowl
   11.10. The lock of a cowl and a cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. A forward wing
   11.13. A luggage carrier cover
   11.14. A latch and the lock of a cover of a luggage carrier
   11.15. A cable of a drive of unlocking of a door of a fuel tank / of a cover of a luggage carrier
   11.16. Facing panels of doors
   11.17. A door
   11.18. A latch, the lock of a door and the handle
   11.19. Door glass
   11.20. Стеклоподъемник
   11.21. Mirrors
   11.22. The central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. The panel of devices
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. A ware tray
+ 12. An electric equipment


75acfaa4

11.10. The lock of a cowl and a cable of a drive of the lock
THE GENERAL DATA

The prevention

Conducting and sockets of system of pneumosafety (SRS-system) have yellow colouring, they are forbidden to be displaced, or to connect to them devices for check.


THE LOCK

PERFORMANCE ORDER
1. Outline contours of the lock of a cowl remove a plastic casing which fastens on percussion caps. Turn away bolts of fastening of the lock (arrow) and remove the lock.
2. Hook and remove the holder of a cable of a drive of the lock and unhook a cable.
3. Installation is carried out upside-down. Adjust lock position so that at cowl closing буферы have been slightly pressed, and the cowl was reliably locked.

CABLE

PERFORMANCE ORDER
1. Hook and remove the holder of a cable of a drive of the lock and disconnect a cable from the lock.
2. Attach to a cable a piece of a wire of sufficient length and release all скобы fastenings of a cover of a cable on a partition передка.
3. Remove plastic protection of a wheel niche (subsection 11.12 see.).
4. In salon remove facing порожка from outside the driver and facing боковины.
5. Turn away 2 screws of fastening of the lever of a drive of a cable of the lock and remove the lever.
6. Extend a cable with a sealant and a wire in salon. Disconnect old and attach a new cable, having tracked presence on it sealants.
7. Stretch a new cable in a cover for a wire.
8. Establish a cable cover in the cable lever, having tracked that the cover tip has densely come into dredging of an arm of the handle of the lever.
9. Further installation is carried out upside-down. Insert a cable sealant into an aperture of a partition of a motor compartment.