Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS-system
   10.4. Колодки disk brakes
   10.5. A brake support
   10.6. A brake disk
   10.7. Колодки drum-type brakes
   10.8. The wheel cylinder of brakes
   10.9. The main cylinder of brakes
   10.10. Hoses and hydrodrive tubes
   10.11. Removal of air from a hydrodrive of brakes
   10.12. The vacuum amplifier of brakes
   10.13. Колодки a lay brake of back disk brakes
   10.14. A lay brake
   10.15. Cables of a lay brake
   10.16. The switch of a signal of braking
   10.17. ABS: a natural choice
   10.18. Malfunctions of brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

10.16. The switch of a signal of braking
THE GENERAL DATA

The switch of a signal of braking

1. Pedal height


2. A pusher


3. The switch of a signal of braking


The switch of a signal of braking is mounted on an arm near to the top part of a pedal.

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight, disconnect from the switch of a signal of braking a conducting socket.
2. Release a counternut and turn out the switch from an arm.
3. Installation is carried out upside-down.

Adjustment

PERFORMANCE ORDER
1. Check up and if necessary adjust pedal height. Subsection 2.23 see.
2. Release a counternut and rotate the switch so that выступание плунжера And corresponded to norm (subsection 10.2 see.). If to check up выступание it is impossible, adjust switch position so that плунжер slightly concerned the terminator of a pedal of a brake. Tighten a counternut.
3. Attach wires to the switch, connect the battery to weight. Check up switch work. Braking signals should light up by pressing a pedal and die away at release pedals. Otherwise repeat adjustment.
4. Check up and if necessary adjust a pedal free wheeling. Subsection 2.23 see.