Toyota Camry

1996-2001 of release

Repair and car operation


Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS-system
   10.4. Колодки disk brakes
   10.5. A brake support
   10.6. A brake disk
   10.7. Колодки drum-type brakes
   10.8. The wheel cylinder of brakes
   10.9. The main cylinder of brakes
   10.10. Hoses and hydrodrive tubes
   10.11. Removal of air from a hydrodrive of brakes
   10.12. The vacuum amplifier of brakes
   10.13. Колодки a lay brake of back disk brakes
   10.14. A lay brake
   10.15. Cables of a lay brake
   10.16. The switch of a signal of braking
   10.17. ABS: a natural choice
   10.18. Malfunctions of brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

10.11. Removal of air from a hydrodrive of brakes
THE GENERAL DATA

Necessity of prorolling of a hydrodrive on all wheels arises after a detachment of tubes on the main cylinder of a brake or at strong fall of level of a liquid in a tank.

At dismantling of a hydrodrive of one wheel it is possible to be limited to air removal only from the understanding cylinder.

If the highway from the main cylinder to wheel it is possible to be limited to air removal only from this highway understood.

PERFORMANCE ORDER
1. On the stopped engine press some times a brake pedal that in the vacuum amplifier of brakes atmospheric pressure was restored.
2. Before prorolling restore liquid level in a tank and during prorolling support level, without supposing a tank devastation. Fill in only a fresh liquid.
3. Prorolling of brakes should be carried out together. Prepare a liquid, a vessel, a hose for prorolling and a key for отворачивания the union.
4. Prorolling begin with a back right wheel. Turn away the union for prorolling and slightly tighten, that it it was possible to turn on again without effort.
5. Attach to the union a hose, other end of a hose lower in a vessel with a brake liquid.
6. Ask the assistant to press slowly a pedal of a brake and to keep.
7. Turn away the union and later 2 сек after a stream of a liquid following with bubbles ослабнет, tighten the union. Ask the assistant to release a pedal.
8. Repeat procedure until then while in a following liquid air vials will not cease to be observed. Tighten the union. Execute these actions in sequence: the left back wheel, the right forward, left forward. Watch liquid level in a tank.
9. Upon termination of prorolling restore liquid level in a tank.
10. After prorolling of brakes the pedal should be "rigid". If necessary repeat prorolling procedure.