Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS-system
   10.4. Колодки disk brakes
   10.5. A brake support
   10.6. A brake disk
   10.7. Колодки drum-type brakes
   10.8. The wheel cylinder of brakes
   10.9. The main cylinder of brakes
   10.10. Hoses and hydrodrive tubes
   10.11. Removal of air from a hydrodrive of brakes
   10.12. The vacuum amplifier of brakes
   10.13. Колодки a lay brake of back disk brakes
   10.14. A lay brake
   10.15. Cables of a lay brake
   10.16. The switch of a signal of braking
   10.17. ABS: a natural choice
   10.18. Malfunctions of brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

10.9. The main cylinder of brakes
THE GENERAL DATA

Details of fastening of the main cylinder

1. The main cylinder
2. A lining
3. The vacuum amplifier
4. The Tee-splitter
5. A splitter (on а/м without ABS-system)

Removal

PERFORMANCE ORDER
1. Disconnect from a tank a socket.
2. Remove a liquid from a tank.
3. Spread rags under the main cylinder.

4. Turn on the union of tubes on the cylinder.

5. Get tubes from unions and take aside.
6. Turn away a nut of fastening of the cylinder to the vacuum amplifier and remove the cylinder.

Installation

PERFORMANCE ORDER
1. Remove air from the cylinder for what clamp the cylinder in a vice for an assembly flange.
2. Screw in the cylinder two tubes, having lowered them in a tank.
3. Fill the cylinder with a liquid of the recommended mark.
4. Slowly press the piston, using, for example big крестовой a screw-driver, and release.
5. Repeat these actions until then while tubes will not cease to leave air.
6. Remove tubes one for another, rolling on their place заглушки.
7. Establish the cylinder into place and wrap nuts by hand.
8. Screw the union without warps, manipulating the cylinder.
9. Tighten a nut and the union.
10. Add a liquid in a tank and remove air from a hydrodrive (subsection 10.11 see.). Air can be removed from the cylinder and on the car, working together. For this purpose ask the assistant to press a pedal some times and to keep. Turn away the union and let the air out. Wrap the union and ask the assistant to release a pedal. Continue while the liquid will not start to follow from the cylinder. At this way lay space under the cylinder rags.
11. Check up work of brakes.