Toyota Camry

1996-2001 of release

Repair and car operation

10.6. A brake disk Check

PERFORMANCE ORDER

1. Release nuts of wheels, lift the car and establish on supports. Remove wheels and wrap nuts of wheels into place to fix a disk concerning a nave (to provide the appendix of effort to a disk it is possible to dress washers). Release a lay brake (at performance of works on a back brake). 2. Remove a support (subsection 10.5 see.), take aside and fix. Turn away bolts and remove a support arm. 3. Check up a condition of a disk from both parties. At detection of traces of deep development (depth more than 1,0 mm), remove a disk and прошлифуйте. If at braking pulsations the raised palpation of a disk can be the reason were marked. In drawing – a disk with traces from the overlays worn out to rivets. A disk with such defects replace. 4. Check up palpation, having established стрелочный the indicator in 13 mm from disk edge. If palpation on the indicator exceeds norm remove a disk and прошлифуйте in car-care centre. The prevention The disk is recommended to be removed and ground periodically irrespective of indicator indications. At least it can be made by hand a small skin to reduce a roughness. 5. After polishing the thickness of a disk should not be less maximum permissible which is cast on a disk. The minimum thickness is specified on a disk inside, near to a fastening place to a nave. 6. Measure a thickness of a disk in several places.

Removal

PERFORMANCE ORDER

1. Turn away wheel bolts which it is temporary крепили a disk, and remove a disk. 2. If the disk of a back brake does not give in to removal turn on заглушку, enter into an aperture a screw-driver (the aperture should be at the very bottom) and rotating a regulator, take away Pads a lay brake from a disk drum from the inside. 3. Rotating a regulator, take away Pads a lay brake from a drum of a disk (front view).

Installation

PERFORMANCE ORDER

1. Establish a back disk on hairpins. 2. Establish an arm of a support and tighten all fastenings with the set moment. 3. Establish a support and tighten fastening bolts. If the brake hose was not disconnected to pump over brakes it is not necessary. 4. Establish a wheel, nuts definitively tighten after car lowering. After assemblage press some times a brake pedal. Check up work of brakes.