Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
- 9. A running gear
   - 9.1.2. Technical characteristics
      9.1.3. The stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. A rack of a forward suspension bracket
      9.1.5. A rack and a suspension bracket spring
      9.1.6. The suspension bracket lever
      9.1.7. Spherical support
      9.1.8. A rotary fist and a nave
      9.1.9. A nave and the bearing of a forward wheel
      9.1.10. The stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. A rack of a back suspension bracket
      9.1.12. A longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. A nave and the bearing of a back wheel
      9.1.15. An arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. A steering
   + 9.3. Semiaxes
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

9.1.3. The stabilizer of cross-section stability of a forward suspension bracket

Installation

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports. Remove forward wheels.
2. Remove the panel of protection of a wing which fastens three bolts.
3. Disconnect steering draughts from the left and right rotary fists (subsection 9.2.3 see.).
4. Disconnect draughts of the stabilizer from a bar, having turned away a nut (arrow). At проворачивании hairpins fix it шестигранным a key. At lever removal turn away the bottom nut.
5. Turn away bolts of fastening of collars of plugs of the stabilizer to an engine frame.
6. Remove forward section of an exhaust pipe.
7. Turn away bolts of fastening of the steering mechanism (subsection 9.2.5 see.).
8. Remove the steering mechanism and get a stabilizer bar from outside the left wheel.

9. Remove rubber plugs and check up their condition. If on plugs damages replace plugs are found out. Check up a condition of hinges of draughts of the stabilizer for what shake 5–6 times the spherical hinge here and there. Then screw a nut and turn it динамометрическим a key (with a scale in some Н.м.) on 1 turn, doing a turn during 2–4 seconds At fulfilment of 5th turn read the instrument of a dynamometer of a key which should be in limits from 0,04 to 0,87 Н.м. Otherwise draught of the stabilizer replace.
10. Clear a place прилегания plugs on a bar of a dirt and a rust.

Installation

PERFORMANCE ORDER
1. Grease new plugs with culinary vegetable oil.
The prevention

It is forbidden to grease plugs at assemblage by mineral oil, oil on an oil basis, or a brake liquid in order to avoid a premature exit of plugs out of operation.


2. The stabilizer is established upside-down.