|
Toyota Camry1996-2001 of releaseRepair and car operation |
|
Toyota Camry + 1. The maintenance instruction + 1.2. The information before car driving + 1.3. Independent maintenance service + 1.4. Technical characteristics + 1.5. Some councils at car purchase + 2. Maintenance service + 3. Engines + 4. Cooling system + 5. Heating and ventilation + 6. Fuel system + 7. An exhaust system + 8. Transmission - 9. A running gear - 9.1.2. Technical characteristics 9.1.3. The stabilizer of cross-section stability of a forward suspension bracket 9.1.4. A rack of a forward suspension bracket 9.1.5. A rack and a suspension bracket spring 9.1.6. The suspension bracket lever 9.1.7. Spherical support 9.1.8. A rotary fist and a nave 9.1.9. A nave and the bearing of a forward wheel 9.1.10. The stabilizer and plugs of the stabilizer of a back suspension bracket 9.1.11. A rack of a back suspension bracket 9.1.12. A longitudinal bar 9.1.13. Levers of a back suspension bracket 9.1.14. A nave and the bearing of a back wheel 9.1.15. An arm of a back suspension bracket 9.1.16. Corners of installation of wheels + 9.2. A steering + 9.3. Semiaxes + 10. Brake system + 11. A body + 12. An electric equipment |
9.1.16. Corners of installation of wheels
Disorder of wheels, longitudinal and cross-section angles of slope of an axis of turn are provided with a design of a suspension bracket and to adjustment are not subject. It is independently supposed to regulate a convergence of forward both back wheels and a limiting angle of rotation of wheels though these procedures are recommended to be executed with a split-hair accuracy in car-care centre. The convergence of wheels is checked on a difference of distances between extreme points on disks of the wheels measured at level of the centre of wheels (measurements are carried out at dry weight of the car when pressure in tyres corresponds to norm, and the car is parked on an equal horizontal platform). At first the distance is measured in a back part of wheels, then the car is rolled on 180 ° and between the same points the distance is measured in their forward part. For accuracy increase it is recommended to measure a convergence on 3 points located on a circle of a disk of a wheel through 120 ° and to define an average convergence. |
|