Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
      3.2.2. Compression check
      3.2.3. The top dead point (ВМТ) piston N1
      3.2.4. Covers of heads of cylinders
      3.2.5. An inlet collector
      3.2.6. Final collectors
      3.2.7. A gazoraspredelitelnyj belt and asterisks
      3.2.8. A forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. The oil pallet
      3.2.13. The oil pump
      3.2.14. The Flywheel / a leading disk
      3.2.15. A back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.2.6. Final collectors

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Grease bolts of collectors пропиточным with oil.
3. Remove oxygen gauges from both collectors.
4. Disconnect a system tube recycling final gases from a back collector and a head of cylinders.

5. Braid nuts, fastening exhaust pipes to collectors.
6. Unscrew bolts and remove collectors.
7. Examine collectors on presence of cracks and other damages.
8. Carefully clean joined surfaces of a collector and a head of cylinders. If you have found out that the collector lining proceeded, check up, whether the collector is deformed, if necessary address to the expert.

Installation

PERFORMANCE ORDER
1. Establish a new lining.
2. Establish a collector and twist bolts.
3. Tighten bolts till the demanded moment of an inhaling.
4. Establish the remained details, get the engine and check up final system on presence of leaks