Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
      3.2.2. Compression check
      3.2.3. The top dead point (ВМТ) piston N1
      3.2.4. Covers of heads of cylinders
      3.2.5. An inlet collector
      3.2.6. Final collectors
      3.2.7. A gazoraspredelitelnyj belt and asterisks
      3.2.8. A forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. The oil pallet
      3.2.13. The oil pump
      3.2.14. The Flywheel / a leading disk
      3.2.15. A back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.2.3. The top dead point (ВМТ) piston N1
THE GENERAL DATA

The highest point which reaches piston N1 at the moment of a compression step is accepted to the top dead point.

Piston N1 is located in a forward part of the right number of cylinders from outside газораспределительного a belt.

Installation

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator and if necessary unscrew spark plugs.
2. Remove an external cover газораспределительного a belt.
3. Turn a cranked shaft so that синхронизационные labels of asterisks of camshafts have been directed upwards and combined with cuts in a cover газораспределительного a belt. On each asterisk is available two labels (see the table of the Label of a camshaft).
4. For piston installation in ВМТ connect a special measuring instrument of pressure in a spark plug aperture.
5. Combine a cut in a pulley of a cranked shaft with a mark a zero (arrow) on a plate with синхронизационными labels. When labels are combined, piston N1 is in ВМТ at the moment of compression.

Camshaft labels

CAMSHAFT
LABEL WHICH IS NECESSARY FOR USING
Final valves of the right head of cylinders
1
Inlet valves of the right head of cylinders
2
Inlet valves of the left head of cylinders
3
Final valves of the left head of cylinders
4