Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
      3.2.2. Compression check
      3.2.3. The top dead point (ВМТ) piston N1
      3.2.4. Covers of heads of cylinders
      3.2.5. An inlet collector
      3.2.6. Final collectors
      3.2.7. A gazoraspredelitelnyj belt and asterisks
      3.2.8. A forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. The oil pallet
      3.2.13. The oil pump
      3.2.14. The Flywheel / a leading disk
      3.2.15. A back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.2.11. Heads of cylinders

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Merge cooling liquid.
3. Remove the top and bottom sections of an inlet collector.
4. Remove final collectors.
5. Remove газораспределительный a belt, asterisks of camshafts and the top intermediate pulley.
6. Unscrew bolts of a back cover газораспределительного a belt.
7. Lift the receiver a cooling liquid.
8. Remove camshafts.
9. Unscrew bolts and disconnect plaits of wires from back parts of heads.

10. Unscrew the drowned bolts of heads.

11. Loosen the other bolts of heads in sequence, the return sequence of their tightening shown in drawing. Weaken bolts on a turn quarter at one time.
12. Remove heads.

Installation

PERFORMANCE ORDER
1. Carefully clean and wipe acetone joined surfaces of heads and the block of cylinders. If surfaces are scratched or damaged otherwise they are necessary for processing in a specialised workshop.
2. By means of a suitable tap clean carvings in the block of cylinders. By means of a suitable die clean bolts of heads of cylinders.
3. Establish a new lining and establish one of heads.
4. Grease bolts with pure engine oil.
5. Insert bolts and tighten them till the demanded moment of an inhaling of the first step in the specified sequence. Do not tighten the drowned bolt.
6. Hold on bolts for 90 ° and tighten the drowned bolt.
7. Similarly establish other head.
8. Establish the remained details.