Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. The top dead point (ВМТ) piston N1
      3.1.4. A cover of a head of cylinders
      3.1.5. An inlet collector
      3.1.6. A final collector
      3.1.7. A gazoraspredelitelnyj belt and asterisks
      3.1.8. A forward epiploon of a cranked shaft
      3.1.9. A camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. A head of cylinders
      3.1.12. The oil pallet
      3.1.13. The oil pump
      3.1.14. The Flywheel / a leading disk
      3.1.15. A back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.1.5. An inlet collector
Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Loosen the a clip, крепящий a hose of the air filter to a throttle, remove the top part of the air filter, the resonator and a hose.

3. Disconnect hoses of system of cooling from a throttle and закупорьте them to avoid leak of a cooling liquid.

4. Disconnect all ropes and the wires fixed on an inlet collector.

4. Not to mix hoses in an installation time make on them labels.

5. Liberate wires from clamps.

6. Disconnect wires of grounding (arrow).

7. Unscrew bolts of an arm of a collector (arrow).

8. Disconnect wires from the coil, unscrew bolts (arrows) and remove a collector arm.

9. Unscrew assembly bolts, braid nuts and disconnect a collector from the engine.

Installation

PERFORMANCE ORDER

1. Carefully clean joined surfaces of a collector and a head of cylinders. If you have found out that the collector lining proceeded, check up, whether the collector is deformed, if necessary address to the expert.

2. Establish a new lining, establish a collector and insert bolts.

3. Tighten bolts till the demanded moment of an inhaling.

4. Establish the remained details, check up, whether draught of a drive of a throttle freely functions, get the engine and check up it on presence of leaks.