Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. The top dead point (ВМТ) piston N1
      3.1.4. A cover of a head of cylinders
      3.1.5. An inlet collector
      3.1.6. A final collector
      3.1.7. A gazoraspredelitelnyj belt and asterisks
      3.1.8. A forward epiploon of a cranked shaft
      3.1.9. A camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. A head of cylinders
      3.1.12. The oil pallet
      3.1.13. The oil pump
      3.1.14. The Flywheel / a leading disk
      3.1.15. A back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.1.12. The oil pallet
Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Lift and fix a forward part of the car.

3. Remove protective guards of the engine.

4. Merge engine oil and remove the oil filter.

5. Braid nuts, fastening forward section of an exhaust pipe to a final collector, unscrew bolts, fastening каталитический the converter to final system, remove an arm and remove forward section of an exhaust pipe. Remove fastening of a final collector.

6. Unscrew bolts (arrows) and remove an arm of the block of cylinders and a transmission.

7. Unscrew bolts and remove the oil pallet from the block of cylinders.

Installation

PERFORMANCE ORDER

1. Carefully clean and wipe acetone joined surfaces of the pallet and the block of cylinders, clean carvings in block apertures. Check up, whether the pallet flange is bent, if necessary correct it.

2. Examine маслозаборный a branch pipe on presence of a contamination of cracks or other damages.

3. Put hermetic on a pallet flange (And – in a flute, In – from an aperture inside).

4. Establish the pallet and insert bolts. Tighten bolts till the demanded moment of an inhaling.

5. Establish the remained details, get the engine and check up it on presence of leaks.