Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. The top dead point (ВМТ) piston N1
      3.1.4. A cover of a head of cylinders
      3.1.5. An inlet collector
      3.1.6. A final collector
      3.1.7. A gazoraspredelitelnyj belt and asterisks
      3.1.8. A forward epiploon of a cranked shaft
      3.1.9. A camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. A head of cylinders
      3.1.12. The oil pallet
      3.1.13. The oil pump
      3.1.14. The Flywheel / a leading disk
      3.1.15. A back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.1.3. The top dead point (ВМТ) piston N1
THE GENERAL DATA

The highest point which reaches piston N1 at the moment of a compression step is accepted to the top dead point.

Piston N1 is located in a forward part of the right number of cylinders from outside газораспределительного a belt.

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator and if necessary unscrew spark plugs.
2. Remove an external cover газораспределительного a belt.
3. Turn a cranked shaft so that синхронизационные labels of asterisks of camshafts have been directed upwards and combined with cuts in a cover газораспределительного a belt. On each asterisk is available two labels (see the table of the Label of a camshaft).
4. Combine a label on a pulley of a cranked shaft (marksman) with the index on a casing of the oil pump. When labels are combined, piston N1 is in ВМТ at the moment of a compression step.

Camshaft labels

CAMSHAFT
LABEL WHICH IS NECESSARY FOR USING
Final valves of the right head of cylinders
1
Inlet valves of the right head of cylinders
2
Inlet valves of the left head of cylinders
3
Final valves of the left head of cylinders
4