Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. The top dead point (ВМТ) piston N1
      3.1.4. A cover of a head of cylinders
      3.1.5. An inlet collector
      3.1.6. A final collector
      3.1.7. A gazoraspredelitelnyj belt and asterisks
      3.1.8. A forward epiploon of a cranked shaft
      3.1.9. A camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. A head of cylinders
      3.1.12. The oil pallet
      3.1.13. The oil pump
      3.1.14. The Flywheel / a leading disk
      3.1.15. A back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.1.16. Engine fastenings
THE GENERAL DATA

Typical fastenings of the 4-cylinder engine

1. The draught regulating displacement of the engine
2. A back support of the engine
3. A mechanical transmission
4. An automatic transmission
5. Collector fastening
6. A forward support of the engine
7. An engine arm

Check

PERFORMANCE ORDER
1. Lift and fix a forward part of the car. Establish a jack under the oil pallet.
2. Examine rubber shock-absorbers of support on presence of deterioration and damages, if necessary replace them.
3. Check up, that bolts of support have been strong tightened.
4. Check up, whether support are worn out.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator. Lift and fix a forward part of the car.
2. To remove the right support, braid a nut and get a through bolt.
3. Braid nuts fastening a support to an arm and remove a support.
4. To remove a back support, get three rubber stoppers and braid support nuts.
5. To remove a forward support, braid a nut, крепящую it to an engine arm, and unscrew three bolts крепящих a support to a body.
6. Installation is made upside-down.