Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. The top dead point (ВМТ) piston N1
      3.1.4. A cover of a head of cylinders
      3.1.5. An inlet collector
      3.1.6. A final collector
      3.1.7. A gazoraspredelitelnyj belt and asterisks
      3.1.8. A forward epiploon of a cranked shaft
      3.1.9. A camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. A head of cylinders
      3.1.12. The oil pallet
      3.1.13. The oil pump
      3.1.14. The Flywheel / a leading disk
      3.1.15. A back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.1.14. The Flywheel / a leading disk

Removal

PERFORMANCE ORDER
1. Lift and fix the car on support. Remove a transmission.
2. Remove press a disk and a disk муфты couplings (for engines with a mechanical transmission).

3. Make adjusting labels (arrow) on a flywheel and on a cranked shaft.
4. Unscrew bolts of a flywheel / of a leading disk, if necessary block a flywheel a screw-driver.
5. Remove a flywheel / a leading disk. In cars with an automatic transmission from both parties of a leading disk intermediate rings are established. At assemblage carrying out, the aperture in an intermediate ring should coincide with a pin (it is specified by an arrow).

Installation

PERFORMANCE ORDER
1. Clean a flywheel and examine its surface on presence of cracks, scratches and the burnt sites. Small damages can be removed, having processed a surface an emery paper. Check up, whether there is no absent teeth and whether the flywheel is deformed.
2. If necessary replace a back epiploon of a cranked shaft.
3. Establish a flywheel on a cranked shaft, using labels made during removal procedure. Put герметизирующий structure on carvings of bolts and insert bolts. Tighten bolts till the demanded moment of an inhaling.