Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
- 9. A running gear
   + 9.1.2. Technical characteristics
   - 9.2. A steering
      9.2.2. A steering wheel
      9.2.3. Tips of steering draughts
      9.2.4. Covers of the steering mechanism
      9.2.5. The steering mechanism
      9.2.6. The hydraulic booster pump
      9.2.7. Removal of air from a contour of the hydraulic booster of a wheel
   + 9.3. Semiaxes
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


9.2.5. The steering mechanism

The steering mechanism and details of its installation

1. The protective panel of the left wing
2, 3. Шплинт
4. The protective panel of the right wing
5. A stabilizer bar

The prevention

At dismantle of the steering mechanism take measures excluding turn of a steering shaft, otherwise it is possible to damage a spiral wire of a pillow of safety. For this purpose the ignition key translate in position "Parking", or wind a wheel with a seat belt and insert a wheel buckle into the lock.

1. Establish wheels in driving position on a straight line. Lift a forward part of the car and establish on supports. Include a lay brake and remove both lobbies of a wheel. Remove protective panels картера the engine (if are provided).
2. Turn on the union of pressure head and return tubes of the hydraulic booster. Muffle tubes. Remove from the steering mechanism an arm.
3. Designate mutual orientation bottom карданного the hinge of a steering shaft and a shaft of the steering mechanism. Turn away a coupling bolt and a nut of a collar (arrow).
4. Disconnect steering draughts.
5. Turn away bolts of fastening of collars of plugs of the stabilizer (for access to bolts of the steering mechanism).
6. Turn away a nut of fastening of the steering mechanism, raise a bar of the stabilizer and beat out bolts of fastening of the steering mechanism.
7. Separate an intermediate shaft from a shaft of the steering mechanism and get the steering mechanism on the right side of the car.
8. Check up a condition of rubber plugs through which the steering mechanism fastens. In need of the plug replace.


1. Establish the steering mechanism and attach карданный the hinge, having combined the labels put at dismantling.
2. Turn and tighten bolts and nuts of fastening of the steering mechanism with the set moment.
3. Attach steering draughts.
4. Tighten a coupling bolt of a collar карданного the hinge.
5. Attach tubes of the hydraulic booster and tighten the union.
6. Establish a stabilizer bar.
7. Lower the car and remove air from a contour of the hydraulic booster of a wheel.