Toyota Camry

1996-2001 of release

Repair and car operation


Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
- 9. A running gear
   + 9.1.2. Technical characteristics
   - 9.2. A steering
      9.2.2. A steering wheel
      9.2.3. Tips of steering draughts
      9.2.4. Covers of the steering mechanism
      9.2.5. The steering mechanism
      9.2.6. The hydraulic booster pump
      9.2.7. Removal of air from a contour of the hydraulic booster of a wheel
   + 9.3. Semiaxes
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

9.2.2. A steering wheel
THE GENERAL DATA
The prevention

Considered cars are equipped by a pillow of safety (SRS-system). At performance of works near to details of a pillow of safety disconnect the battery in order to avoid operation of system and traumas.

Removal

PERFORMANCE ORDER
1. Translate the ignition key in position OFF and disconnect the battery from weight. Remove the positive plug of the battery and wait not less than 2 minutes
2. Turn a wheel and establish wheels in driving position on a straight line, hook a screw-driver and remove заглушки screws on both parties of a wheel. Release two screws of fastening of the module of a pillow of safety (1 – the screw with крестовым шлицем, 2 – the screw case). Screws release until then while dredging on a screw head will not come into an aperture of the case of the screw.
3. Remove the safety module.
4. Press a socket clamp
5. Disconnect a socket.
6. Disconnect sockets of a sound signal and cruise-control system.
7. Turn away a nut of fastening of a wheel and designate position of a wheel concerning a shaft (on parts of cars of a label of orientation of a wheel are put by the manufacturer).
8. Выпрессуйте a steering wheel. Remove a wheel a stripper. It is forbidden to remove a wheel blows on a nave.

Installation

PERFORMANCE ORDER
1. Be convinced that wheels are established in driving position on a straight line. Turn a spiral wire counter-clockwise to sensation of hard rotation. Turn a wire clockwise on three turns and combine two indexes of red colour. At correct installation the spiral should turn in both parties on three turns.
2. Combine wheel and shaft labels, establish a wheel and tighten a nut with the set moment.
3. Attach sockets of the cruise-control and a sound signal.
4. Attach a socket of the module of safety.
5. Establish the module of safety and tighten screws with the set moment.
6. Attach to the wire battery.