Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Transmission
   + 8.1.2. Care manual transmission
   + 8.2. An automatic transmission
   - 8.3. Coupling
      8.3.2. Coupling – the description and check
      8.3.3. Coupling details
      8.3.4. The vyzhimnoj bearing and a plug
      8.3.5. The main cylinder of coupling
      8.3.6. The working cylinder of coupling and the accumulator
      8.3.7. A coupling hydrodrive
      8.3.8. The blocking switch of coupling
      8.3.9. slip
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

8.3.2. Coupling – the description and check
THE GENERAL DATA

Coupling dry, one-disk диафрагменного type with a hydraulic drive.

Consistently main and working cylinders through which transfer of effort from a pedal on a plug and on выжимной the bearing of deenergizing of coupling is provided are included in a hydrodrive contour. On cars with engine V6 the hydroaccumulator is in addition provided.

It is recommended to execute following preliminary checks which allow to define a coupling condition.
PERFORMANCE ORDER
1. Check up liquid level, if necessary restore (if the tank is empty, add a liquid and pump over a hydrodrive).
2. For coupling check press a pedal idling the engine and after some seconds include a reverse gear. The gnash will specify in the strengthened deterioration of press or frictional disks.
3. Check up completeness of deenergizing of coupling. For this purpose on the working engine press a coupling pedal so that the pedal did not reach a floor on 13 mm. Be some times switched from 1st transfer to the back. The complicated switching specifies in deterioration of details. Check up a course of a rod of the working cylinder at completely pressed pedal. If the course is small, check up liquid level.
4. Be convinced that the plug of coupling has no люфта on a spherical support.
5. Check up deterioration of the plug of a pedal in the top part.