Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Transmission
   + 8.1.2. Care manual transmission
   - 8.2. An automatic transmission
      8.2.2. Technical characteristics
      8.2.3. Care automatic gearbox
      8.2.4. The general diagnostics
      8.2.5. A rope of the lever of a gear change
      8.2.6. A rope throttle заслонки
      8.2.7. The switch of blocking of ignition
      8.2.8. System of blocking of the lever of a gear change
      8.2.9. Replacement of epiploons
      8.2.10. Removal and installation automatic gearbox
      8.2.11. An electronic control system
      8.2.12. "Automatic machine"
   + 8.3. Coupling
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

8.2.5. A rope of the lever of a gear change

Adjustment
PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Remove the protective guards closing space межу by a forward part of the car and the bottom cross-beam.
3. Loosen the a nut of the switching lever on a transmission (it is specified by an arrow).
4. Establish switching lever in parking position (against the stop upwards), and then on two clicks downwards in neutral position (4-cylinder models, transmission А140Е).
5. Establish switching lever in parking position (against the stop downwards), and then on two clicks upwards (6-cylinder models, transmission А541Е).
6. Establish the gear change lever in salon in neutral position.
7. Tighten a lock nut.
8. Check up, how the lever of switching and a transmission functions.

Replacement

PERFORMANCE ORDER
1. Disconnect a rope from the switching lever on a transmission (the nut is specified by an arrow).
2. Remove the big clamp of a rope (it is specified by an arrow), located over the lever. Disconnect a rope from an arm.
3. Unscrew bolts of a clamp of a rope (are specified by arrows), located on a dividing partition.
4. Remove the central panel.
5. Remove the big clamp of a rope.
6. Remove a wire clamp, beat out a lock pin (it is specified by an arrow) and disconnect a rope from the gear change lever.
7. Remove a rope.
8. Installation is spent upside-down removals.