Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Transmission
   + 8.1.2. Care manual transmission
   - 8.2. An automatic transmission
      8.2.2. Technical characteristics
      8.2.3. Care automatic gearbox
      8.2.4. The general diagnostics
      8.2.5. A rope of the lever of a gear change
      8.2.6. A rope throttle заслонки
      8.2.7. The switch of blocking of ignition
      8.2.8. System of blocking of the lever of a gear change
      8.2.9. Replacement of epiploons
      8.2.10. Removal and installation automatic gearbox
      8.2.11. An electronic control system
      8.2.12. "Automatic machine"
   + 8.3. Coupling
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

8.2.10. Removal and installation automatic gearbox

Removal
PERFORMANCE ORDER
1. Remove a cowl.
2. Lower pressure in fuel system.
3. Disconnect a wire of the minus plug of the accumulator.
4. Remove the accumulator and an accumulator shelf.
5. If the car is equipped by cruise-control system disconnect a wire from the block of the working mechanism of system (it is specified by an arrow) and remove the block.
6. Remove a starter.
7. Uncover a jellied mouth of a fuel tank and disconnect the fuel tubes connecting the engine with a body.
8. Disconnect tubes (are specified by arrows) radiator трансмиссионной liquids from a transmission.
9. Disconnect a wire from the switch of system of blocking of the lever of a gear change.
10. Disconnect a wire from the gauge of speed.
11. Disconnect ropes from the lever mechanism throttle заслонки.
12. Disconnect from a transmission all hoses and wires (the bolt of a wire of grounding is specified by an arrow). Mark the ends of all disconnected hoses and wires not to mix them in an installation time.
13. Remove cooling fans. Merge cooling liquid, remove a radiator and all hoses of system of cooling and a heating system.
14. Disconnect a rope of the lever of a gear change from a transmission.
15. Loosen the bolts of forward wheels, lift the car and fix it on support. Fix the engine on the lift. Remove forward wheels.
16. Remove an arm of a final collector.
17. Remove forward section of an exhaust pipe.
18. Remove protective guards.
19. Merge трансмиссионную a liquid.
20. Remove semiaxes.
21. Unscrew bolts of a forward support of the engine.
22. Braid nuts of the left support of a transmission.
23. Remove a back support of the engine.
24. In models equipped with steering transfer with the amplifier, disconnect steering transfer from a suspension bracket.
25. Unscrew four bolts of an arm of the stabilizer of stability.
26. Tie up steering transfer to a body and unscrew bolts. Steering transfer should not disturb to transmission removal.
27. Unscrew bolts of a cross-beam of a suspension bracket. Removing a cross-beam, do not forget to make adjusting labels.
28. Establish a jack under a transmission.
29. Remove edges of rigidity from the left and right parties of a transmission.
30. Unscrew bolts (are specified by arrows) hydrotransformer covers.
31. Unscrew bolts, fastening the hydrotransformer to a leading disk.
32. Unscrew bolts, fastening the top part of a casing of a transmission to the engine.
33. Unscrew bolts, fastening the bottom part of a casing of a transmission to the engine.
34. Disconnect a transmission from the engine and accurately lower it.

Installation

Transmission installation is spent upside-down сняытия.