Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
      3.2.2. Compression check
      3.2.3. The top dead point (ВМТ) piston N1
      3.2.4. Covers of heads of cylinders
      3.2.5. An inlet collector
      3.2.6. Final collectors
      3.2.7. A gazoraspredelitelnyj belt and asterisks
      3.2.8. A forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. The oil pallet
      3.2.13. The oil pump
      3.2.14. The Flywheel / a leading disk
      3.2.15. A back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.2.12. The oil pallet
Removal

PERFORMANCE ORDER

1. Remove a cowl.

2. Disconnect a wire of the minus plug of the accumulator.

3. Lift and fix a forward part of the car.

4. Remove protective guards of the engine.

5. Merge engine oil and remove the oil filter.

6. Disconnect forward section of an exhaust pipe from каталитического the converter, an arm and final collectors.

7. Unscrew two bolts and uncover a flywheel casing.

8. Unscrew bolts, fastening aluminium section of the pallet to a transmission.

9. Unscrew bolts and remove steel section of the pallet.

10. Unscrew bolts маслозаборного a branch pipe (arrow) and remove it.

11. Unscrew bolts of aluminium section of the pallet.

12. If necessary remove a dividing partition of the pallet.

Installation

PERFORMANCE ORDER

1. Carefully clean and wipe acetone joined surfaces of both sections of the pallet and the block of cylinders, clean carvings in block apertures. Check up, whether the pallet flange is bent, if necessary correct it.

2. Establish a dividing partition.

3. Put hermetic on a joined surface of aluminium section.

4. Establish aluminium section and tighten bolts till the demanded moment of an inhaling.

5. Examine маслозаборный a branch pipe on presence of a contamination of cracks or other damages. Establish a branch pipe (if you removed it) and tighten bolts.

6. Put hermetic on a flange of steel section of the pallet. Establish section, insert bolts and tighten them till the demanded moment of an inhaling.

7. Establish the remained details, get the engine and check up it on presence of leaks.