Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
      3.2.2. Compression check
      3.2.3. The top dead point (ВМТ) piston N1
      3.2.4. Covers of heads of cylinders
      3.2.5. An inlet collector
      3.2.6. Final collectors
      3.2.7. A gazoraspredelitelnyj belt and asterisks
      3.2.8. A forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. The oil pallet
      3.2.13. The oil pump
      3.2.14. The Flywheel / a leading disk
      3.2.15. A back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. A partition of engines
   + 3.4. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

3.2.5. An inlet collector

Removal

PERFORMANCE ORDER

1. Pit pressure in fuel system and disconnect a wire of the minus plug of the accumulator.

THE TOP CHAMBER OF THE COLLECTOR

PERFORMANCE ORDER
2. Merge cooling liquid.
3. Unscrew two bolts (arrow) and uncover the engine.
4. Remove the air filter.
5. Disconnect wires and hoses from a throttle, disconnect a rope throttle заслонки.
6. Disconnect a system tube recycling (marksman) of final gases from the chamber.
7. Remove two arms of the chamber.
8. Unscrew bolts () and braid nuts (), fastening the chamber, to the inlet collector located more low and remove the chamber.

THE BOTTOM PART OF THE COLLECTOR

PERFORMANCE ORDER
2. Disconnect wires from fuel injectors.
3. Disconnect a heater hose () and a hose of giving of air () from a collector disconnect a fuel hose from a fuel highway.
4. Unscrew bolts and braid nuts (arrow), remove the bottom section of a collector – figures specify sequence of a tightening of bolts and nuts.
5. Under the bottom part of a collector the hose of a cooling liquid (arrow) is located. If you have removed an inlet collector, insistently it is recommended to replace an old hose with the new.

Installation

PERFORMANCE ORDER
1. Carefully clean and wipe acetone joined surfaces of a collector and heads.
2. Establish new linings and establish the bottom section of a collector and tighten bolts till the demanded moment of an inhaling.
3. Establish the remained details.