Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Heating and ventilation
   5.2. The control panel a heater and the air conditioner
   5.3. A heater radiator
   + 5.4. A central air and heating
   5.5. An electric chain of coupling of the compressor of the air conditioner
   5.6. Влагоотделитель air central airs
   5.7. The compressor of the air conditioner
   5.8. A refrigerator of a central air of air
   5.9. The evaporator of a central air of air
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


75acfaa4

5.2. The control panel a heater and the air conditioner

Removal and installation
PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the central finishing panel and remove radio.
3. Remove handles of management and unscrew control panel screws (are specified by arrows).
4. Disconnect wires (are specified by arrows) from the control panel – model Avalon.
5. Disconnect two ropes (are specified by arrows) from a back part of the control panel – model Avalon. Remove the control panel.
6. Installation is spent upside-down removals.

Adjustment of operating ropes

PERFORMANCE ORDER
1. To adjust a rope operating заслонкой of an air inlet, establish the lever in position FRESH, establish and fix a rope.
2. To adjust a rope operating an air mix, establish the lever of an air mix in position COOL, establish and fix a rope (it is specified by an arrow).

Check of an electric chain

PERFORMANCE ORDER
1. Check up the central air switch, having connected a tester to contacts 2 and 5. When the switch is translated in position ON, a chain between contacts 2–5 and 3–4 should be closed.
2. Test the switch of modes (see the table).
3. To replace any details of the control panel, remove handles (), unscrew cover screws () and unscrew screws of switches ().

Position of the handle of the switch
Contacts
Necessary condition
FACE
1 – 6
The chain is closed
B/L
1 – 5
The chain is closed
FOOT
1 – 4
The chain is closed
FOOT/DEF.
1 – 3
The chain is closed
DEF.
1 – 2, 7 – 8
The chain is closed