Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Heating and ventilation
   5.2. The control panel a heater and the air conditioner
   5.3. A heater radiator
   + 5.4. A central air and heating
   5.5. An electric chain of coupling of the compressor of the air conditioner
   5.6. Влагоотделитель air central airs
   5.7. The compressor of the air conditioner
   5.8. A refrigerator of a central air of air
   5.9. The evaporator of a central air of air
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

5.9. The evaporator of a central air of air

THE GENERAL DATA

Arrangement of a casing of the evaporator

1. The block of the delivery fan
2. The amplifier of the air conditioner (4-cylinder engines)
3. The regulating valve
4. The amplifier of the air conditioner (6-cylinder models)
5. The electric motor of the delivery fan
6. The resistor негнетательного the fan
7. The thermoresistor
8. A heater radiator
9. The evaporator
10. The servo-driver заслонки воздуховыпускного apertures
11. The control panel of the air conditioner
  – The conditioner switch
  – A gearshift of the delivery fan
  – The switch of modes
12. The block of the air conditioner

The evaporator casing is located under the central part of the instrument panel, near to the delivery fan.

Removal

PERFORMANCE ORDER

1. Lower pressure in system.

2. Disconnect a wire of the minus plug of the accumulator.

3. Disconnect two tubes of a coolant (are specified by arrows) from a partition.

4. In models 1999 for a detachment of tubes of a coolant, the special tool is used.
1. Press from above.
2. Turn рычажок.
3. Pull upwards.

5. Merge cooling liquid and disconnect hoses from the heater block.

6. Remove furnish of a control panel and a control panel.

7. Disconnect wires from the evaporator and a casing of the delivery fan.

8. Remove the block of sockets of the electric wires, located in the bottom part of the delivery fan. Remove clamps and an air pipe. Unscrew assembly bolts of a casing of the delivery fan (are specified by arrows). Remove the block of the delivery fan.

9. Unscrew bolts, fastening the broad valve to the evaporator.

10. Remove evaporator clamps, disconnect a drain hose and remove an evaporator casing.

11. Remove the thermostat gauge, unscrew screws and get the evaporator from a casing.

Installation

Installation is spent upside-down removals.