Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
- 9. A running gear
   - 9.1.2. Technical characteristics
      9.1.3. The stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. A rack of a forward suspension bracket
      9.1.5. A rack and a suspension bracket spring
      9.1.6. The suspension bracket lever
      9.1.7. Spherical support
      9.1.8. A rotary fist and a nave
      9.1.9. A nave and the bearing of a forward wheel
      9.1.10. The stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. A rack of a back suspension bracket
      9.1.12. A longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. A nave and the bearing of a back wheel
      9.1.15. An arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. A steering
   + 9.3. Semiaxes
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

9.1.6. The suspension bracket lever
Removal

PERFORMANCE ORDER

1. Lift a forward part of the car and remove a wheel from that party from which the suspension bracket lever will be dismantled.

2. Disconnect draught of the stabilizer from the lever (subsection 9.1.3 see.).

3. Turn on specified a bolt and nuts of fastening of a spherical support to the lever.

4. Operating with mount, take away the lever of a suspension bracket from a rotary fist.

5. Turn away two bolts of fastening of a forward part of the lever of a suspension bracket to a frame of the engine (arrow).

6. Turn away a bolt and a nut of fastening of a back part of the lever of a suspension bracket to a frame of the engine (arrow).

7. Remove the lever.

Check

PERFORMANCE ORDER

1. Check up presence on the lever of deformations. At curvature detection replace the lever. Рихтовка the lever it is forbidden.

2. Check up a condition of plugs of the lever. At detection on plugs of cracks, ruptures and traces of strong deterioration the lever in gathering replace.

Installation

PERFORMANCE ORDER

1. Installation is carried out upside-down. All carving connections tighten with the set moments.

2. Establish a wheel and lower the car.

3. Check up and if necessary adjust corners of installation of wheels.