Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder двухрядные engines V6 of 3,0 l
   + 3.3. A partition of engines
   - 3.4. An engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. The storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. The coil () ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. The block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. A pressure and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay
      3.4.15. The basic malfunctions of an electric equipment
      3.4.16. That it is necessary to know to the owner of the car with инжекторным the engine
      3.4.17. A turbo the doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.4.7. Check of the moment of ignition

THE GENERAL DATA

The prevention
Procedure of installation of the moment of ignition is applicable almost to all cars considered in the given Management. If the order of installation of the ignition, specified in подкапотной to the car tablet, differs from described more low be guided by the tablet instruction. The ignition moment on all considered cars is not regulated, therefore, at infringement of installation of ignition it is necessary to check up serviceability of units of system of ignition.

PERFORMANCE ORDER

1. Connect a tachometre, being guided by the instruction of the manufacturer of the device.

2. Find a diagnostic socket and close накоротко conclusions Е1 and ТЕ1.

3. At the switched off ignition connect a stroboscope, being guided by the instruction of the manufacturer of the device.

4. Find labels of the moment of ignition (arrow) on a forward cover and on a pulley коленвала.

5. Warm up the engine, be convinced that turns of idling of the engine of 700 rpm on а/м from a manual transmission and 750 rpm on а/м with automatic transmission. Direct stroboscope light on a scale. The label on a pulley коленвала should be opposite to corresponding division of a scale.