1. Clean surfaces of the block of cylinders and the balancing device, establish linings. |
2. Establish the first piston in the top dead point. |
3. Combine labels (deepening) on shaft with cuts corresponding to them in a casing of shaft. |
|
4. Establish the balancing device on the block and insert bolts. Tighten bolts till the demanded moment of an inhaling in the specified sequence. |
5. Measure trailer backlashes of shaft by means of a special measuring instrument. If backlashes exceed as much as possible admissible limits, address to the expert. |
|
6. Measure a district backlash of a tooth gearing of shaft N1 in four various positions (1 – a gear wheel of a cranked shaft, 2 – a gear wheel of shaft N1). |
|
7. Cовместите a label And shaft N1 with a cut in a casing also measure a district backlash (1 – the top half of casing, 2 – shaft N1). |
|
8. Cовместите a label In shaft N1 with a cut in a casing also measure a district backlash. |
9. If the shaft free wheeling exceeds admissible limits, adjust its size by means of adjusting linings. |