|
|
Toyota Camry1996-2001 of releaseRepair and car operation |
|
|
Toyota Camry + 1. The maintenance instruction + 1.2. The information before car driving - 1.3. Independent maintenance service 1.3.1.2. An engine oil choice 1.3.1.3. Check of level of a cooling liquid of the engine 1.3.1.4. A choice of type of a coolant 1.3.1.5. Check and replacement of the filter of the air conditioner - 1.3.2. Wheels and tyres 1.3.2.2. Check and replacement of tyres 1.3.2.3. Shift of tyres 1.3.2.4. Installation of tyres for movement on snow and chains противоскольжения 1.3.2.5. Replacement of wheels + 1.3.3. Electric components 1.3.4. The water additive in a washer tank + 1.3.5. Replacement of lighting lamps + 1.4. Technical characteristics + 1.5. Some councils at car purchase + 2. Maintenance service + 3. Engines + 4. Cooling system + 5. Heating and ventilation + 6. Fuel system + 7. An exhaust system + 8. Transmission + 9. A running gear + 10. Brake system + 11. A body + 12. An electric equipment 
|
1.3.2.5. Replacement of wheels
When it is necessary to replace wheels If the wheel has damage, for example, a bend, a crack or strong corrosion, – it should be replaced. Otherwise the tyre can slide off a wheel or it will lead to management loss. Choice of wheels Wheels should be replaced by at what same safe load, diameter, width of a rim and a start. The wheel of other size or type can negatively influence driving, wheel and bearing service life, cooling of brakes, speedometer / calibration одометра, ability of a stop, aiming of headlights, bumper height, a road clearance of the car and an interval from the tyre or a chain противоскольжения to a body and the chassis. Replacement by the used wheels is not recommended. Never use a tyre tube in a wheel with leak which has been designed for бескамерной tyres. After passage by the car of the first 1600 km check up, that nuts of wheels have been normally tightened. If shift, repair or replacement of tyres was carried out, check up, that nuts of wheels have been still tightened after passage of 1600 km. At use of chains be cautious not to damage aluminium wheels. Use only nuts of wheels and wrench Toyota, intended for aluminium wheels. At balancing of wheels use only counterbalances of firm Toyota or equivalent to them and a plastic or rubber hammer. The same as and at use of any wheels, periodically check aluminium wheels on damage. If it is, immediately replace a wheel. |
|