Toyota Camry

1996-2001 of release

Repair and car operation



Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
- 11. A body
   11.2. Vinyl furnish
   11.3. An upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. A windscreen and motionless glasses
   11.8. The central lock
   11.9. A cowl
   11.10. The lock of a cowl and a cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. A forward wing
   11.13. A luggage carrier cover
   11.14. A latch and the lock of a cover of a luggage carrier
   11.15. A cable of a drive of unlocking of a door of a fuel tank / of a cover of a luggage carrier
   11.16. Facing panels of doors
   11.17. A door
   11.18. A latch, the lock of a door and the handle
   11.19. Door glass
   11.20. Стеклоподъемник
   11.21. Mirrors
   11.22. The central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. The panel of devices
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. A ware tray
+ 12. An electric equipment


75acfaa4

11.9. A cowl
THE GENERAL DATA

The prevention

Works should be carried out together.


Removal

PERFORMANCE ORDER
1. Open a cowl and cover a blanket the next panels of a body.
2. Disconnect all wires which can prevent cowl removal, and also screen wiper tubes.
3. Outline contours of loops of a cowl.

4. On models Avalon remove скобы clamps and disconnect cowl racks. The assistant thus keeps a cowl.

5. Turn away fastening bolts to loops and with the assistant remove a cowl.
6. Installation is carried out upside-down. At installation combine the contours of loops put earlier.

Adjustment

Adjustment of position of a cowl is provided with its moving to apertures under bolts of fastening of loops after easing of bolts and nuts.


The prevention

The bolts of a cowl established by the manufacturer, are "aligning" and adjustments it is not required. For adjustment of position of a cowl concerning loops it is necessary to replace these bolts standard with flat and spring washers.


PERFORMANCE ORDER
1. Outline contours of loops.
2. Release bolts and move a cowl to the necessary position a little. Tighten bolts and cautiously close a cowl for adjustment check.
3. If necessary adjust position of the lock of a cowl. To adjust lock position across or on a vertical release bolts of fastening of the lock (arrow), preliminary having outlined contours of bolts, and move a cowl in the necessary direction. After adjustment bolts tighten.
4. In last turn position of buffers that the cowl at closing has appeared заподлицо with the next panels is regulated. Position is regulated by rotation of these buffers located on a partition передка (at rotation counter-clockwise the cowl rises and on the contrary).
5. Periodically grease the lock литолом.