Toyota Camry

1996-2001 of release

Repair and car operation


Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
- 11. A body
   11.2. Vinyl furnish
   11.3. An upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. A windscreen and motionless glasses
   11.8. The central lock
   11.9. A cowl
   11.10. The lock of a cowl and a cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. A forward wing
   11.13. A luggage carrier cover
   11.14. A latch and the lock of a cover of a luggage carrier
   11.15. A cable of a drive of unlocking of a door of a fuel tank / of a cover of a luggage carrier
   11.16. Facing panels of doors
   11.17. A door
   11.18. A latch, the lock of a door and the handle
   11.19. Door glass
   11.20. Стеклоподъемник
   11.21. Mirrors
   11.22. The central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. The panel of devices
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. A ware tray
+ 12. An electric equipment


75acfaa4

11.17. A door
THE GENERAL DATA
The prevention

Work is carried out together.

Removal

PERFORMANCE ORDER
1. Lower glass and disconnect the battery from weight.
2. Open and substitute under a door a support.
3. Remove the facing panel of a door.
4. Designate and disconnect all sockets, wires on weight, get all скобы fastenings of wires.
5. Remove from a door a rubber trench.
6. Turn away a bolt of fastening of the terminator of opening of a door.
7. Designate position of loops on a door.
8. Supporting a door, turn away bolts of loops and remove a door (in drawing the top loop is shown).
9. For access to bolts of a back door (arrow) open a forward door.

Installation

Installation is carried out upside-down.

Adjustment

PERFORMANCE ORDER
1. Check up a condition of axes of loops. If at качании doors in вртикальном a direction люфт exceeds 1,5 mm it is necessary to replace loops.
2. The door is regulated by moving to apertures of loops of a door at the released bolts (on a body or on a door). After adjustment bolts tighten. After adjustment the door should be заподлицо with the next panels of a body, backlashes on a door contour should be uniform and small. If to adjust a door it is not possible, between a loop and a body it is necessary to lay washers.
3. Check up adjustment of a clamp of the lock of a door on a vertical and horizontals. The latch uvula should adjoin to the clamp centre. Otherwise adjust.
4. For clamp adjustment release screws and move a clamp in the necessary direction easy blows of a hammer. At correct adjustment across the door should be заподлицо with the central rack (or a back wing) and to be locked without the big effort.