Toyota Camry

1996-2001 of release

Repair and car operation

Toyota Camry
+ 1. The maintenance instruction
+ 1.2. The information before car driving
+ 1.3. Independent maintenance service
+ 1.4. Technical characteristics
+ 1.5. Some councils at car purchase
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmission
+ 9. A running gear
+ 10. Brake system
- 11. A body
   11.2. Vinyl furnish
   11.3. An upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. A windscreen and motionless glasses
   11.8. The central lock
   11.9. A cowl
   11.10. The lock of a cowl and a cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. A forward wing
   11.13. A luggage carrier cover
   11.14. A latch and the lock of a cover of a luggage carrier
   11.15. A cable of a drive of unlocking of a door of a fuel tank / of a cover of a luggage carrier
   11.16. Facing panels of doors
   11.17. A door
   11.18. A latch, the lock of a door and the handle
   11.19. Door glass
   11.20. Стеклоподъемник
   11.21. Mirrors
   11.22. The central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. The panel of devices
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. A ware tray
+ 12. An electric equipment


11.15. A cable of a drive of unlocking of a door of a fuel tank / of a cover of a luggage carrier
1. Disconnect a cable and remove a latch of a cover of a luggage carrier (subsection 11.14 see.).
2. For access to a cable of a door of a mouth of a tank remove a rug of a luggage carrier and left боковину facings. Turn a cable tip counter-clockwise on 1/4 turns and get from an arm (model Camry).
3. On models Avalon get a tip of a cable from an arm and deduce from gearing with the locking mechanism of a door of a mouth of a tank.
4. Remove the bottom part of a back seat (subsection 11.27 see.). On two-door models (coupe) it is necessary to remove a back and the bottom part of a seat.
5. Hook and remove an overlay порожка doors of the driver. On 4-door models remove the bottom facing of the central lateral rack of a body.
6. Raise a floor rug and remove all latches of fastening of a cable to a body.
7. Turn away two screws of fastening of the handle of a cable to a floor.
8. Raise the case and disconnect covers of cables from скоб and eyes on levers.
9. Attach to a cable a piece of a wire of sufficient length.
10. Stretch a cable from outside a luggage carrier to a wire exit.
11. Attach to a wire a new cable and stretch a new cable to the lever for a wire.
12. Further installation is carried out upside-down.